当前位置:网站中华彩票官网 > 新闻中心 > 行业动态
行业动态
  • 数控攻丝机的操作需要注意哪些?
  • 本站编辑:xghl发布日期:2018-07-13 16:14 浏览次数:

数控精密攻丝机BSK-100桌式

数控攻丝机的操作规程
Operation rules of numerical control tapping machine
1、开始操作前,检査主要锁紧螺栓是否坚固,电源开关及线路是否良好。按规定穿着劳保用品,非攻丝工和未持证的攻丝工禁止上岗。
1, before starting operation, check whether the main locking bolts are solid, and whether the power switches and lines are good. According to the regulations, the workers who wear the labor insurance products, the non tapping workers and the non certified tapping workers are not allowed to take up posts.
2、操作前必须在规定加油部位注入润滑油、剂、脂等。待该机运转正常、灵活、可靠 后期方能操作。
2, before operation, injection of lubricating oil, agent, grease and so on must be provided at the refueling area. When the machine is running normally, flexibly and reliably, it will be able to operate in the later stage.
3、攻丝前,必须将所需攻丝的工件、工具等摆放整齐、顺手。
3, before tapping, the necessary tapping parts and tools must be placed neatly and smoothly.
4、调试数控攻丝机所攻丝的丝锥大小勾深度符合要求的尺寸后再开始作业,防止滑丝。
4. Debug the tapping depth of the CNC tapping machine to meet the required size and then start the operation to prevent slipping.
5、数控攻丝机攻丝时排出的杂物(铁渣粉沫等),应留有空位或槽穴以方便杂物排 出。随吋淸理。
5. When the tapping machine is used for tapping, the waste materials (such as iron slag powder, etc.) should be left empty or slot to facilitate the discharge of debris. With inches.
6、经常自检工件,互检工件,做到无一个有瑕疵的零配件,不允许弄虛作假。
6, often self check workpiece, mutual inspection of workpiece, so that there is no defective parts, do not allow fraud.