当前位置:网站中华彩票官网 > 新闻中心 > 行业动态
行业动态
  • 自动钻床操作规程
  • 本站编辑:xghl发布日期:2018-07-11 17:04 浏览次数:

1.工作前必须全面检查各部操作机构是否正常,将摇臂导轨用细棉纱擦拭干净并按润滑油牌号注油。

1. before work, we must check whether the operating agencies are normal or not. Wipe the rocker guideway with fine cotton yarn and fill the oil according to the grade of the lubricating oil.


2.摇臂和主轴箱各部锁紧后,方能进行操作。

2. the parts of the rocker arm and the headstock are locked before they can be operated.


3.摇臂回转范围内不得有障碍物。

There shall be no obstacles in the range of 3. rocker revolving.

2-160929103T8-51.jpg

4.开钻前,钻床的工作台、工件、夹具、刃具,必须找正,紧固。

4. before drilling, the worktable, workpiece, jig and cutting tool of drilling machine must be fixed and fastened.


5.正确选用主轴转速、进刀量,不得超载使用。

5. correct selection of spindle speed and feed quantity should not be used for overload.


6.超出工作台进行钻孔,工件必须平稳。

6. go beyond the worktable for drilling, and the workpiece must be stable.


7.机床在运转及自动进刀时,不许变紧固换速度,若变速只能待主轴完全停止,才能进行。

7. when the machine is running and automatically feeding, it is not allowed to change the speed of fastening. If the speed change can only stop the spindle completely, it can be carried out.


8.装卸刃具及测量工件,必须在停机中进行,不许直接用手拿工件钻削、不得戴手套操作。

8. loading and unloading tools and measuring workpieces must be carried out during shutdown. No hand drilling is allowed and no gloves should be used.


9.工作中发现有不正常的响声,必须立即停车检查排除故障。

9. abnormal noise is found in the work. It must be stopped immediately to check the trouble shooting.